Clean Efflorescence Off Concrete & Brick Surfaces With Our Easy-To-Use Product!
Use To Clean 1,500 Square Feet Of Low Absorbent Materials, Or 750 Square Feet Of Highly Absorbent Materials
Basic Application:
- Do not apply Efflorisn't if ambient temperature is below 28 degrees F.
- Clean affected area of loose debris (dirt, dust, excess crystallization, etc.) to help open surface pores and ensure maximum penetration.
- Apply Efflorisn't using a pump-up garden sprayer or an airless sprayer at low pressure. Spray area which shows signs of efflorescence thoroughly, using enough liquid to make the surface appear damp yet not causing "dripping" or "run-off". Wipe off excess to ensure even coverage.
- Allow Efflorisn't to soak for one hour then clean with a hard bristled brush. Pending on the type and amount of efflorescence present, repeat Step 3 if needed.
- Rinse using a constant water source (hose, power washer, etc.), liberally spraying down the area where Efflorisn't was applied.
Efflorisn't is designed to take the efflorescence particles below the surface with it as it is absorbed. On very dense, sealed, or vertical surfaces, a white, powdery residue may be left behind after application process. These residues are typically crystalline efflorescence, not true efflorescence, and are mineral deposits left behind from an outside water source (rain, sprinkler system, runoff from another area, etc.). These residues can usually be eliminated by repeating Steps 3-5 above or by washing the area with soap/white vinegar and water after the true efflorescence has been removed.
*Note: When applying Efflorisn't do not allow solution to get on glass or aluminum. Etching and discoloration may occur. If Efflorisn't does come in accidental contact with any materials other than those intended, flush the area immediately with water to minimize potentially irreversible damage.
Coverage
Because Efflorisn't can be used on such a wide variety of surface materials, the actual coverage area per gallon will vary. As a basic rule, you can expect one gallon of Efflorisn't solution to cover approximately 300 square feet on low absorbent materials and 150 square feet on highly absorbent materials. See the Contributing Factors to Efflorisn't Performance section above for a more complete list of factors that influence actual coverage.
Contributing Factors to Efflorisnt Performance:
- Density of Material
- Ambient Temperature / Weather Conditions
- Moisture Content of Material
- Dilution Ratio
- Amount / Type of Efflorescence Present
- Source of Efflorescence
- Previous Treatments (e.g. Sealants) Applied to Surface
- Age of Material
To become a distributor of Efflorisn't, call us today at 203-376-9180. |
|
